That is convict labour! But it takes so long to take shape.
The first wire harness piece is ready. 2x relay for the main power supply, with the fuel pump, starter relay, and the cable for the kill switch. What I had envisaged was simple: The fabric tube has to cut to length very closely because if it is too long and the shrink tubes are on it and then it subsequently inflates, which can be scary. That’s not nice. The crimping of the individual pins can be done quite well with the hand. I just don’t want to make any mistakes, or else I would just lose my rag with the control device. That would be disastrous; it would be just like flushing money down the toilet. Practice makes perfect, after a couple of practices with the wire harnesses, the handwork will surely improve.